14
ENA 7
T Place a cup of milk below the 2-stage
frothing nozzle and immerse the nozzle in
the milk.
If the nozzle does not reach into the cup, lift
E
the cup.
n T Press the Steam button.
HEATING
As soon as the ENA has heated up, READY
appears again.
l T Turn the switch anticlockwise to position m.
STEAM, the milk is frothed by the hot
steam.
y T Turn the switch clockwise to position o
when the milk foam has reached the
required consistency.
You can continue to prepare steam for the
E
next 40 seconds or so without the machine
having to heat up again.
T Place a cup under the coffee spout.
< T Press the Espresso button to start prepara-
tion.
1 ESPRESSO, the preset amount of
water flows into the cup.
Preparation stops automatically.
To make sure the 2-stage frothing nozzle always
works properly, it should be rinsed regularly (see
Chapter 5 ‘Maintenance – Dismantle and rinse the
2-stage frothing nozzle’).
Hot milk with the 2-stage frothing nozzle
Precondition: READY is displayed.
T Push the 2-stage frothing nozzle to the
upper position.
T Place a cup of milk below the 2-stage
frothing nozzle and immerse the nozzle in
the milk.
If the nozzle does not reach into the cup, lift
E
the cup.
T Prepare steam (see Chapter 2 ‘Preparation –
Cappuccino with the 2-stage frothing
nozzle’).
Hot water
To prepare hot water, either attach the E
hot-water nozzle or the 2-stage frothing
nozzle to the Connector System
©
.
J CAUTION
There is a danger of scalding from hot water
splashes.
T Avoid direct contact with the skin.
Precondition:
READY is displayed.
T Place a cup under the hot-water spout.
l T Turn the switch anticlockwise to position m.
WATER, hot water flows into the cup.
y T Turn the switch clockwise when there is
sufficient water in the cup.
READY
To Next Page
Loading...
