E During preparation, you can change the
preset amounts (e.g. amount of milk foam
or water) by turning the Rotary Switch g.
E You can follow the current status of
preparation on the progress bar.
E The water volume is given as standard in
OZ. You can change this setting to ML in
programming mode (see Chapter 4 ‘Perma-
nent settings in programming mode – Unit
for amount of water’).
Coffee tastes best served hot. A cold porcelain cup
cools the beverage – and impairs the taste. We
therefore recommend prewarming the cups. The
full coffee aroma can develop only in prewarmed
cups. You can purchase a JURA cup warmer from
your specialised dealer.
You can make permanent settings for all products
in programming mode (see Chapter 4 ‘Permanent
settings in programming mode – Products’).
Espresso, coffee
Preparation of espresso < and coffee > follows
this model.
Example: Proceed as follows to prepare one coffee.
Precondition:
READY is displayed.
T Place a cup under the dual spout.
> T Press the Coffee button to start preparation.
COFFEE, the preset amount of water
flows into the cup.
Preparation stops automatically.
READY
Latte macchiato, cappuccino
Your ENA can prepare a latte macchiato or
cappuccino at the touch of a button. There is no
need to move the glass or cup.
Preparation of latte macchiato ( and cappuccino
/ follows this model.
Example: Proceed as follows to prepare one latte
macchiato.
Precondition:
READY is displayed.
T Place a glass under the dual spout.
T Remove the protective cover of the dual
spout.
T Connect the milk pipe to the dual spout.
T Immerse the other end of the milk pipe in a
receptacle with milk (figure: optional JURA
0.4 liter (14 oz) stainless steel vacuum milk
container).
E Ensure that the filling height of the milk is
no higher than the milk pipe connection on
the dual spout.
( T Press the Latte Macchiato button.
LATTE MAC., the milk foam is prepared.
Preparation stops automatically when the
preset amount of milk is reached.
PAUSE
E There is a short interval while the hot milk
separates from the milk foam. This allows
the typical layers of a latte macchiato to
form. You can choose the length of this
interval in programming mode (see
Chapter 4 ‘Permanent settings in program-
ming mode – Products’).
LATTE MAC., coffee preparation starts.
The preset amount of water flows into the
glass.
Preparation stops automatically.
READY
micro 9
To Next Page
Loading...
