Jura ENA Micro 9 One Touch - Rinses; Unit for Amount of Water

20
4 Permanent settings in programming mode
k T Press the Rotary Switch to confirm the
setting.
OK, the switch-off time is set.
OFF AFTER
g T Turn the Rotary Switch until EXIT is
displayed.
k T Press the Rotary Switch to exit programming
mode.
READY
Rinses
In the program item RINSES you can make the
following settings:
U
INIT RINSE MANUAL
U
The switch-on rinse must be started
manually.
U
INIT RINSE AUTOMATIC
U
The switch-on rinse is started automatically.
U
C-RINSE AFTER10'
U
You are prompted to perform a cappuccino
rinse 10 minutes after preparation of a
specialty coffee with milk.
U
C-RINSE NOW
U
You are prompted to perform a cappuccino
rinse immediately after preparation of a
specialty coffee with milk.
Example: Change the setting such that cappuccino
frother rinsing is performed immediately after
preparation of a specialty coffee with milk.
Precondition:
READY is displayed.
k T Press and hold the Rotary Switch until
RINSE appears.
g T Turn the Rotary Switch until
RINSES is
displayed.
k T Press the Rotary Switch to enter the
program item.
INIT RINSE
g T Turn the Rotary Switch until C-RINSE is
displayed.
k T Press the Rotary Switch to enter the
program item.
AFTER10'
g T Turn the Rotary Switch until NOW is
displayed.
k T Press the Rotary Switch to confirm the
setting.
OK
C-RINSE
g T Turn the Rotary Switch until EXIT is
displayed.
k T Press the Rotary Switch to exit the program
item.
RINSES
g T Turn the Rotary Switch until EXIT is
displayed.
k T Press the Rotary Switch to exit programming
mode.
READY
Unit for amount of water
The water volume is given as standard in OZ. You
can change this setting to
ML in programming
mode.
Example: Change the unit for the amount of water
from
OZ to ML.
Precondition:
READY is displayed.
k T Press and hold the Rotary Switch until
RINSE appears.
g T Turn the Rotary Switch until
DISPLAY is
displayed.
k T Press the Rotary Switch to enter the
program item.
OZ
g T Turn the Rotary Switch until ML is displayed.
k T Press the Rotary Switch to confirm the
setting.
OK, the unit for the amount of water is set.
DISPLAY
g T Turn the Rotary Switch until EXIT is
displayed.
k T Press the Rotary Switch to exit programming
mode.
READY