16
2 Preparation
product to start preparation. The following additional products are
shown in the product selector view:
‘Ristretto’
‘Special’
‘Macchiato’
‘Flat White’
‘Caffè latte’
‘1 portion milk foam’
‘Espresso doppio’
‘Jug of coffee’
‘Hot water for black tea’
‘Hot water for green tea’
‘2x Ristretto’
‘2x Espresso’
‘2x Coffee’
‘2x Special’
‘2x Caffè Barista’
‘2x Lungo Barista’
‘2x Cappuccino’
‘2x Latte macchiato’
‘2x Macchiato’
‘2x Flat White’
‘2x Caffè latte’
‘2x 1 portion milk’
‘2x 1 portion milk foam’
E The product selector view disappears automatically after
10seconds if no preparation is started.
E The last product selected always appears first in the product
selector view.
E You can move any of the standard products programmed in
your X10 to your preferred position on the start screen and
make it one of your favourites. You can duplicate and person-
alise your favourite speciality coffees by giving them a new
product name and individual settings (e.g. amount and coffee
strength) (see Chapter 4 ‘Permanent settings in programming
mode – Adjusting the product settings’). Please note that the
descriptions provided in the following sections always refer to
the default settings.
Example:Proceed as follows to prepare one coffee.
Precondition:The start screen is displayed.
T Place a cup under the dual spout.
T Touch ‘Coffee’.
Preparation starts. The preset amount of water for coffee
flows into the cup.
Preparation stops automatically. The start screen is dis-
played.
Preparing speciality
coffees