23
4 Permanent settings in programming mode
4 Permanent settings in programming mode
Touch ‘P’ to enter programming mode. Move your finger across the
display to navigate through the programme items and permanently
save the desired settings. The following settings can be made:
Programme item Sub-item Explanation
‘Maintenance status’
(‘1/4’)
‘Clean’,
‘Change the filter’
(only if filter is fitted),
‘Descale’,
‘Clean the milk system’,
‘Rinse’,
‘Maintenance information’
‘Lock display’
T Here you can start the required mainte-
nance programme or find out what mainte-
nance actions are required.
‘Machine settings’
(‘2/4’)
‘Switch off after’
T Set the time after which the X10 should
switch off automatically.
‘Save energy’
T Activate energy-saving mode.
‘Lock/enable’
T Disable various machine functions of the
X10.
‘Werkseinstellung’
TReset the machine to its factory setting.
‘Unit’
T Select the unit for the amount of water.
‘Display’
TChange the display brightness.
‘Water hardness’
T You can set the water hardness of the water
used.
‘Choose language’
T Select your language.
‘Connect accessory’,
‘Disconnect accessories’
(Only displayed if the
JURA Smart Connect is
being used.)
T Connect the X10 wirelessly to a JURA
accessory or disconnect the connection
again.
‘Empty system’
T Empty the system to protect it from frost
during transport.
‘Version’ Software version
‘Start screen’
T Change the number of products displayed
on the start screen.