JVA ZM1 - Configuring a Z114 to Run in Bi-Polar Mode; Jumpers

JVA ELECTRIC FENCE SYSTEMS
19
Technical Information
6.3 Jumpers
Jumper Function Purpose
J3 Inhibit Mains fail error.

intention is to operate the energizer on DC only
(as in solar power systems).
J4

Off to return programmable
options to factory defaults on
power up.
If the energizer needs to be defaulted to factory
settings, remove all power (AC and battery) and


the Energizer will be reset to default settings.
6.4 ConguringaZ114toruninBi-Polarmode


Step 1
On the back of the Z114 PCB near the high voltage output terminals there is a link

both points where it is soldered to prevent any arcing.
Step 2
Set Fence Mode (programming option 15)
to bipolar.
Value Function
0 
1 Conventional
Z114 Programming Option 15