English
Page 28
Specifications
Amplifier
Output Power At Stereo Operation
Front Channels 50 watts per channel, min. RMS, driven into 4 ohms at 1 kHz with
no more than 0.9% total harmonic distortion. (IEC268-3/DIN)
30 watts per channel, min. RMS, driven into 8 ohms at 1 kHz with
no more than 0.9% total harmonic distortion. (IEC268-3/DIN)
30 watts per channel, min. RMS, driven into 8 ohms, 40 Hz to 20
kHz with no more than 0.8% total harmonic distortion.
At Surround Operation
Front Channels 40 watts per channel, min. RMS, driven into 8 ohms at 1 kHz with
no more than 0.8% total harmonic distortion.
Center Channel 40 watts, min. RMS, driven into 8 ohms at 1 kHz, with no more
than 0.8% total harmonic distortion.
Rear Channels 40 watts per channel, min. RMS, driven into 8 ohms at 1kHz, with
no more than 0.8% total harmonic distortion.
Total Harmonic Distortion 0.8 %* at 30 watts output
(8 ohms, 1 kHz) (* Measured by JVC Audio Analysis System)
Frequency Response (8 ohms) PHONO 20 Hz to 20 kHz (±1 dB)
TUNER, CD, TAPE, VCR, VIDEO 20 Hz to 20 kHz (±1 dB)
Audio Input Sensitivity/ PHONO (MM) 2.5 mV/47 k ohms
Impedance (1 kHz) TUNER, CD, TAPE, VCR, VIDEO 200 mV/47 k ohms
Audio Output Level TAPE, VCR 200 mV
Signal-to-Noise Ratio PHONO 70 dB/66 dB
(’66 IHF/DIN) TUNER, CD, TAPE, VCR, VIDEO 87 dB/67 dB
RIAA Phono Equalization ±0.5 dB (20 Hz to 20 kHz)
Loudness +5 ± 2 dB at 100 Hz
(Volume Control at –40 dB)
Video Input Sensitivity/ VCR, VIDEO 1 Vp-p/75 ohms
Impedance
Video Output Level VCR, MONITOR OUT 1 Vp-p (at 1 Vp-p input)
Synchronization negative
Signal-to-Noise Ratio 45 dB
General
Power Requirements AC 230V , 50 Hz
Power Consumption 240 watts
5 watts (in standby mode)
Dimensions (W x H x D) 435 x 146 x 403 mm
(17
3
/16 x 5
3
/4 x 15
7
/8 inches)
Mass 8.0 kg (17.7 lbs)
Design & specifications are subject to change without notice
AX-V5BK(EF)_0023-001A_En 97.4.24, 1:15 PM28
To Next Page
Loading...
