JVC CA-C55BK User Manual

6-1 (bL07' ON)
Programming Hints
cu
Repeat a selection or
the CDs
cb
CHANGER
Cc)
10 REPEAT
io NR
To delete the program and exit program mode, press the @/CANCEL button on the Unitrepeatedly untilall the program
steps are deleted, and then press the PLAY MODE bution until “CONTINUE” appears on the display.
Q You can skip to a particular program step by pressing the SEARCH/EDIT TIME Ié<4 or 4 button during
program play.
G1 To play the programmed tracks over and over, press the REPEAT on the remote controller so that “REPEAT”
lights up on the display.
A few Hints to Make Programming Easier
To check the program contents (the Unit must be in stop mode)
Q Each time you press the CALL button on the Unit, the program contents are shown on the CD/tuner display in
the programmed order.
To change the program contents
Q Press the CALL button until the CD/uner display shows the program step to correct. Enter the new disc number
and/or track number, which will replace the ones originally showing.
Q To delete a program step, press CALL button until the CD/tuner display shows the program step to delete, then
the press M/CANCEL button.
© You can use both of these ways to change program steps during programming as well as later.
Repeating a Selection or the Discs
You can have all the discs, the program or the individual selection currently playing repeal as many times as you like by
pressing the REPEAT on the Remote controller.
1. Press the CD CHANGER on the Remote controller.
2. Press the REPEAT on the Remote controller.
Each time you press the REPEAT, il cycles from function-off, which turns “REPEAT” out on the CD/tuner display,
to “REPEAT” which will repeat all the tracks in order or according to the program you have set, and then to “REPEAT
1” which will repeat the currently playing track.
To exit repeat mode, press the REPEAT so that neither “REPEAT” or “REPEAT 1” lights on the display.
& Press the REPEAT before or during random play to instruct the CA-C55BK to continue with a different random track
selection after the last selection of the last disc is played.
Using the Cassette Deck
AUTO REVERSE
Listen to a tape:
How to use your
cassette deck
pm ie
Playback procedure
Finding the place
you want:
Music Scan
Scan back
Scan forward
Listening to a Tape
The cassette deck allows you to play, record and dub audio tapes.
QO Most tapes are now recorded with the Dolby NR system, so first check which type of the Dolby NR system has been
used on the tape. Only the Dolby B NR is incorporated into the CA-C55BK.
With Automatic Tape Detection, you can listen to type For II tapes without changing any settings.
One Touch Play
By pressing either the [> or <1 button on either deck A or B, the Unit will come on, and ifa tape is in the deck, it will
start to play. If no tape is loaded, the Unit will come on and wait for further instructions.
Regular Play
When the power is already on, you can use this basic procedure:
1. Press the EJECT button for the deck you want (o use.
2. When the cassette carrier opens, put the cassette in, with the exposed part of the tape down toward the base of the CA-
CS55BK.
If the cassette carrier does not open, turn the Unit off, then back on again and press the EJECT button.
3. Close the carrier gently.
4. Presst> to play the front side, or <<Ito play the reverse side. The arrow indicator on the pressed button starts blinking
and tape play starts.
To stop playing, press the l@ button.
To remove the tape, press the EJECT button.
Fast Left and Fast Right
Q While the tape is stopped, press the «#€ bution and the tape will wind rapidly onto the left side of the cassette
without playing.
Q While the tape is stopped, press and the tape will wind rapidly onto the right side of the cassette without
playing.
Music Scan
To find the beginning of a music track during play, use the Music Scan function. Music Scan searches for blank portions
that usually separate tracks, then plays the next song.
If you use Music Scan on deck A while recording on deck B, recording will stop.
To find the beginning of the current song
Press the <t<€ or > buiton during play.
Q Make sure that you press the <4 or ®® button in the opposite direction to tape play. Searching stops
automatically at the beginning of the current song, and the current song starts automatically.
To find the beginning of the next song
Press the <4 or ®® bution during play.
Make sure that you press the <4 or > button in the same direction as tape play. Searching stops automatically
at the beginning of the next song, and the next song starts automatically.
13

JVC CA-C55BK Specifications

General

Brand	JVC
Model	CA-C55BK
Category	Stereo Receiver
Language	English