JVC DLA-X500RBE - Data Backup of DD Sub PWB; Pixel Shift and Lens Position Adjustment; MAC Address Writing

(No.PA048<Rev.002>)1-21
4.4.5 DATA BACKUP OF DD SUB PWB
Note :
Perform the operation with the power ON.
Input the signal from external equipment.
BACKUP PROCEDURE
(1) Run the DDROM Writer application program.
(2) Select the serial COM Port.
(3) Click [DD Adjust Mode] set ON.
(4) Click A0 of [Read From ROM] and save the anf0 file to
the PC.
(5) In the similar procedure for save the A2,A4,A6 memory.
(6) Click [DD Adjust Mode] set OFF.
UPLOAD PROCEDURE
(1) Run the DDROM Writer application program.
(2) Select the serial COM Port.
(3) Click [DD Adjust Mode] set ON.
(4) Click A0 of [Write to ROM] and load of backup the anf0
file to the PC.
(5) In the similar procedure for the A2,A4,A6 memory.
(6) Click [DD Adjust Mode] set OFF.
4.4.6 PIXEL SHIFT
PROCEDURE
(1) Input color cross-hatch signal.
(2) From the Service menu, set <Adjust> to <Pixel Shift>.
(3) Adjust [H Pixel Adj.R], [H Pixel Adj.B] to make H direction
(Pixel Shift) to become the best point.
(4) Adjust [V Pixel Adj.R], [V Pixel Adj.G] to make V direction
(Pixel Shift) to bectom best point.
4.4.7 LENS POSITION RESET
PROCEDURE
(1) Set lens shift position to mechanical center.
(2) Execute to Lens Position Reset.
4.4.8 MAC ADDRESS WRITING
Note :
Perform this operation during standby mode.
PROCEDURE
(1) Run the Mac AddressWriter application program.
(2) Select the serial COM Port.
(3) Set the Mac Address, and Click [Write].
(4) Confirm the OK display.
MAC ADDRESS display position
MAC address is listed in the bar code label of PROCESSOR
PWB in the set.
Number of "MA" or later is the MAC address.
Please fill in the MAC address in the PROCESSOR PWB after
the exchange.
Instruments DDROM Writer REPLACING
COMPONENTS
zDD SUB PWB
Te st po in t
Adjustment menu
Preparation
Instruments REPLACING
COMPONENTS
zOPTICAL
BLOCK
Te st po in t
Adjustment menu Service menu <Adjust>
→ <Pixel shift>
Preparation
Instruments REPLACING
COMPONENTS
zOPTICAL
BLOCK
Te st po in t
Adjustment menu Service menu <Option>
→
<Lens Position Reset>
Preparation
Instruments Mac AddressWriter REPLACING
COMPONENTS
zPROCESSOR
PWB
Te st po in t
Adjustment menu
Preparation
BAR CODE LABEL