JVC GR-AX30U User Manual

AM-V700U
(provided)
AUDIO IN and
VIDEO IN connectors
42
EDITING TECHNIQUES (Cont'd
’INSERTZEDTING.
Insert editing means recording a new scene into a
section of prerecorded tape so that a part of the
original recording can be replaced with a new
sequence without excessive picture distortion at the
edit-in and edit-out points. In the Insert Editing mode,
the original audio on the audio track remains
unchanged.
IB Set the power switch to “PLAY”.
Locate the desired edit-out point on the tape and
press PAUSE.
Press COUNTER RESET, then COUNTER
MEMORY.
Press REW to rewind the tape a little beyond the
beginning of the scene you wish to insert.
Press PAUSE exactly at the beginning of the scene
to insert.
While holding INSERT pressed, press PAUSE.
— The VideoMovie enters the Insert Editing mode
with the scene at which the VideoMovie is aimed
appearing on the screen for monitoring.
i Press START/STOP to insert the new sequence.
@ When the counter reading of “0:00:00” is reached,
insert editing stops automatically and the
VideoMovie enters the Playback mode.
Notes:
a When in the Stilt mode, the counter indication may
be blurred. This is normal.
= When the tape reaches the preset edit-out point
during the editing operation, it may stop slightly
before or after the designated point on the tape.
Also, at that time, noise bars may appear
momentarily. Neither of these is a defect of the unit.
™ Only video signal is recorded in the Insert Editing
mode. When the sound is to be recorded, press A.
DUB and PAUSE simultaneously in the Insert Pause
mode. When INSERT and PAUSE are pressed
simultaneously again, the unit re-enters the Video-
signal-only Recording mode.
To AUDIO and
=} VIDEO out connectors
AV output cable (provided)
Viewlinder
RM-V700U
(provided)
2AUBDIO DUBBING
Audio dubbing means recording a new soundtrack on
a pre-recorded tape, i.e., replacing the original sound
with new audio material.
Precautions
™ Tapes with their safety tabs removed cannot be
audio dubbed. Reseal the safety tab slot to perform
the dubbing.
If whistling or howling is heard during audio dubbing,
reduce the TV volume or move the mike farther
away from the TV.
ll Set the power switch to "PLAY".
i Locate the desired edit-out point on the tape and
press PAUSE.
Press COUNTER RESET, then COUNTER
MEMORY.
El Press REW to locate more quickly the place on the
tape you want to begin.
Press PAUSE at the exact beginning point.
E@ While pressing A. DUB, press PAUSE to enter the
Audio Dub Standby mode.
Press PLAY. — Audio dubbing begins.
u When the counter reading of "0:00:00" is reached,
audio dubbing stops automatically and the
VideoMovie enters the Playback mode.
43

JVC GR-AX30U Specifications

General

Brand	JVC
Model	GR-AX30U
Category	Camcorder
Language	English