_UVLLa_VfZ_VU EN _
• • • .=- • oo o =_ |, .==_,
DThe light source or the subject does not include • The date/time is not set.
white. Or there are various different light sources .',).Set the date/time. ( pg. 14)
behind the subject. • The built-in clock battery has run out and the
",).Find a white subject and compose your shot so previously set date/time has been erased.
that it also appears in the frame. ( pg. 29) -,).Consult your nearest JVC dealer for replacement.
D Shooting was performed under backlit conditions.
-).Press BACK LIGHT. (pg. 31)
DThe subject is too bright.
-)*Set '_" to "SPOTLIGHT". (pg. 34)
• This is not a malfunction.
4By recording with "DIS" activated ( pg. 22, 24)
this can be avoided.
.= . - . , s_ o . -¢
DThe Sepia (SEPIA) or Monotone (MONOTONE)
mode is activated.
",).Disengage the Sepia (SEPIA) or Monotone
(MONOTONE) mode before setting White
Balance. ( pg. 34)
DThe Sepia (SEPIA) or Monotone (MONOTONE)
mode is activated.
",).Disengage the Sepia (SEPIA) and Monotone
(MONOTONE). ( pg. 34)
DWhen shooting in the dark, the unit becomes
highly sensitive to light when 'GAIN UP" is set to
AUTO".
If you want the lighting to look more natural, set
GAIN UP" to "AGC" or "OFF". ( pg. 22, 23)
Otherproblems
Charging is difficult in places subject to extremely
high/low temperatures.
-).To protect the battery, it is recommended to
charge it in places with a temperature of 10°C to
35°C (50°F to 90°F), ( pg. 43)
The battery pack is not attached firmly.
-).Detach the battery pack once again and re-attach
it firmly. ( pg. 11)
• The DV cable was plugged/unplugged with power
turned on.
-).Turn the camcorder's power off and on again,
then operate it.
• In places subject to low temperature, images
become dark due to the characteristics of the
LCD monitor. This is not a malfunction.
-,).Adjust the brightness and angle of the LCD
monitor. (pg. 15, 18)
• When the LCD monitor's fluorescent light reaches ,e,
the end of its service life, images on the LCD t.
monitor become dark.
-).Consult your nearest JVC dealer.
a
• The LCD monitor and the viewfinder are made
with high-precision technology. However, black
spots or bright spots of light (red, green or blue)
may appear constantly on the LCD monitor or the
viewfinder. These spots are not recorded on the
tape. This is not due to any defect of the unit.
(Effective dots: more than 99.99 %)
• The battery's charge is low.
-,)Install a fully charged battery. ( pg. 11)
To Next Page
Loading...
Need help?
General
