GETTING STARTED
14 EN
MasterPage: Left
The language on the display can be changed.
(墌 pg. 23, 26)
1 Open the LCD monitor fully.
2 Set the Power Switch to “REC” or “PLAY”
while pressing down the Lock Button located on
the switch.
● If set to “REC”, the recording mode should be
set to “M”. (墌 pg. 19)
3 Press MENU.
4 Select “SYSTEM”, press SET or .
5 Select “LANGUAGE”, press SET or .
6 Select the desired language, press SET or .
7 Press MENU.
Press whenever you want to return to the
previous menu screen.
The date/time is recorded onto the tape at all
times, but its display can be turned on or off.
(墌 pg. 25, 27)
Perform steps
1 – 3 in “Language Settings”.
(墌 pg. 14)
1 Select “DISPLAY”, press SET or .
2 Select “CLOCK ADJ.” press SET or .
3 Select the desired date display format, press
SET or .
● Repeat this step to input time display format (Select
from “24h” or “12h”), month, date, year, hour and
minutes.
4 Press MENU.
Press whenever you want to return to the
previous menu screen/setting.
1 Set the Power Switch to “REC” while
pressing down the Lock Button located on the
switch.
2 Make sure the LCD monitor is closed and
locked. Pull out the viewfinder fully.
3 Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
CAUTION:
When retracting the viewfinder, take care not to
pinch your fingers.
Perform steps 1 – 3 in “Language Settings”.
(墌 pg. 14)
● To adjust the brightness of the viewfinder, pull
out the viewfinder fully and set “PRIORITY” to
“FINDER”. (墌 pg. 26)
1 Select “DISPLAY”, press SET or .
2 Select “BRIGHT”, press SET or .
3 Select the appropriate brightness,
press SET or .
4 Press MENU.
Press whenever you want to return to the
previous menu screen/setting.
Language Settings
Date/Time Settings
LANGUAGE
ENGLISH
FRANCAIS
NEDERLANDS
ITALIANO
ESPAÑOL
1
2
SET
Select
CLOCK ADJ.
DATE. MONTH. YEAR
24
h
2
:
26
6. 9. 2007
1
2
Select
SET
Viewfinder Adjustment
Brightness Adjustment Of The
Display
Dioptre Adjustment Control
Example:
BRIGHT
±
0
2
SET
Select
GR-D750AA.book Page 14 Tuesday, January 30, 2007 5:41 PM
To Next Page
Loading...
