EN27
To Delete Unwanted Still Images . . .
.... when unwanted still images are stored in the memory
card or its memory is full, refer to “Deleting Images”
(墌 pg. 32) and delete unwanted still images.
To Remove The Shutter Sound . . .
.... when you do not want to hear the shutter sound, set
“BEEP” to “OFF” in the Menu Screen (墌 pg. 46, 48).
The sound is no longer heard from the speaker.
NOTES:
●
Even if “MULTI-4” or “MULTI-9” is engaged, Snapshot
recording will be performed in the FULL mode during
Digital Zoom or Night-Scope (
墌
pg. 38).
●
Even if “DIS” is set to “ON” (
墌
pg. 47), the Stabiliser
will be disabled.
●
If Snapshot recording is not possible, “PHOTO” blinks
when SNAPSHOT is pressed.
●
If Programme AE with special effects (
墌
pg. 38) is
engaged, certain modes of Programme AE with special
effects are disabled during Snapshot recording. In such a
case, the icon blinks.
●
If shooting is not performed for approx. 5 minutes when
the Power Switch is set to “ ” or “ ” and power is
supplied from the battery pack, the camcorder shuts off
automatically to save power. To perform shooting again,
set the Power Switch to “OFF”, then to “ ” or “ ”.
●
The Motor Drive mode (
墌
pg. 42) is disabled when the
VIDEO/DSC Switch is set to “ ”.
●
Still images taken are compliant to DCF (Design rules for
Camera File systems). They do not have any compatibil-
ity with devices which are not compliant to DCF.
FULL
Snapshot mode
with no frame*
PIN-UP
Pin-Up mode*
FRAME
Snapshot mode
with frame*
MULTI-4
Multi-Analyser 4
* There is the sound effect of a shutter closing.
MULTI-9
Multi-Analyser 9
To Next Page
Loading...
Need help?
General
