JVC GR-DVL150 - Dubbing Memory Card to Tape

EN55
T
P
O
US
C
H
OP
“
Y
SN
T
A
O
PS
T
H
A
O
P
T
E
”
REC
SNAPSHOT Button
Fast-Forward Button (
3 )
Rewind Button (
2 )
Lock Button
Dubbing Images Stored In A Memory Card
To A Tape
(GR-DVL557/DVL555/DVL357/DVL355 only)
Images can be dubbed from a memory card to a tape.
1
Load a memory card (墌 pg. 14) and cassette
(墌 pg. 12).
2
To locate the point where you wish to dub a still
image, play back the tape. Stop playback at the
desired point.
3
2
Set the VIDEO/DSC Switch to “ ”, then set the
Power Switch to “ ” while pressing down the
Lock Button located on the switch.
4
3
To select a still image to be dubbed, perform Index
Playback (墌 pg. 29), Auto Playback (墌 pg. 28) or
press 2 or 3 to select the image you wish.
5
To engage Dub-Standby, press SNAPSHOT. The
message “TO COPY TO TAPE PUSH "SNAPSHOT"”
appears.
6
While the message is being displayed, press
SNAPSHOT. The selected still image is recorded on
the tape for approx. 5 seconds.
•The indicator disappears when dubbing is
complete.
NOTE:
If SNAPSHOT is pressed in step 5 when the tape’s erase
protection tab is set to “SAVE”, the message “COPYING
FAILED” is displayed.
Display
Power Switch
VIDEO/DSC Switch
(Open the LCD monitor
to access this switch.)