30 EN
SNAP MODE –
FULL
MUL T I –
4
MUL T I –
9
PIN–UP
FRAME
FOR RECORDING
(cont.)
Snapshot
This feature lets you record still images that look like
photographs onto a tape.
SNAPSHOT MODE SELECTION
1
Set the Power Switch to “ ” while pressing down the
Lock Button located on the switch.
2
Press the MENU/BRIGHT wheel in. The Menu Screen
appears.
3
Rotate the MENU/BRIGHT wheel to select “
CAMERA”. Press it and the CAMERA Menu appears.
4
Rotate the MENU/BRIGHT wheel to select “SNAP
MODE”, then press it.
5
Rotate the MENU/BRIGHT wheel to select the desired
Snapshot mode, then press it.
Rotate the MENU/BRIGHT wheel to select
“
1
RETURN” and press it twice. The Menu Screen closes.
SNAPSHOT RECORDING
1
Press SNAPSHOT.
If you press during Record-Standby . . .
..... “PHOTO” appears and a still image will be recorded
for approx. 6 seconds, then the camcorder re-enters
the Record-Standby mode.
If you press during Recording . . .
..... “PHOTO” appears and a still image will be recorded
for approx. 6 seconds, then the normal recording
resumes.
•Regardless of the Power Switch position (“ ” or “ ”),
Snapshot recording takes place using the selected
Snapshot mode.
Motor Drive Mode
Keeping SNAPSHOT pressed provides an effect similar to serial
photography. (Interval between still images: approx. 1 second)
NOTES:
●
To remove the shutter sound,
墌
“BEEP” on pg. 34, 36.
●
Even if “MULTI-4” or “MULTI-9” is engaged, Snapshot
recording will be performed in the FULL mode during
Digital Zoom or Night-Scope (
墌
pg. 26).
●
If Snapshot recording is not possible, “PHOTO” blinks when
SNAPSHOT is pressed.
●
If Programme AE with special effects (
墌
pg. 26) is engaged,
certain modes of Programme AE with special effects are
disabled during Snapshot recording. In such a case, the icon
blinks.
●
If SNAPSHOT is pressed when “DIS” is set to “ON”
(
墌
pg. 35), the Stabiliser will be disabled.
●
During tape playback as well, all snapshot modes are
available. However, the shutter sound is not heard.
●
During Snapshot recording, the image displayed in the
viewfinder may be partially missing. However, there is no
effect in the recorded image.
●
When a cable is connected to the AV connector, the shutter
sound is not heard from the speaker, however it is recorded
onto the tape.
●
will appear while the snapshot is being taken.
Power Switch
SNAPSHOT Button
Lock Button
Display
Menu Screen
FULL
Snapshot mode with
no frame*
PIN-UP
Pin-Up mode*
FRAME
Snapshot mode with
frame*
MULTI-4
Multi-Analyser 4
* There is the sound effect of a shutter closing.
MULTI-9
Multi-Analyser 9
To Next Page
Loading...
