EasyManua.ls Logo

JVC GR-DVL40 - Playback; Basic Playback

JVC GR-DVL40
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN29
PLAYBACK
A
M
P
L
A
Y
O
F
F
Still Playback:
Pauses during playback.
1) Press
4
/6 during playback.
2) To resume normal playback, press
4
/6 again.
If still playback continues for more than about 3 minutes, the camcorders Stop mode is automatically
engaged. After 5 minutes in the Stop mode, the camcorder’s power is automatically turned off.
When
4
/6
is pressed, the image may not pause immediately while the camcorder stabilizes the still
image. During this time, if PAUSE
(6)
on the remote control is pressed, Slow-Motion Playback will
start. This is not a malfunction.
Shuttle Search:
Allows high-speed search in either direction.
1) Press
3
for forward or
2
for reverse search during playback.
2) To resume normal playback, press
4
/6.
During playback, press and hold
2
or
3
. The search continues as long as you hold the button.
Once you release it, normal playback resumes.
A slight mosaic effect appears on screen during Shuttle Search. This is not a malfunction.
Slow-Motion Playback, Frame-By-Frame Playback, Playback Zoom and
Playback Special Effects
Available only with the RM-V711U remote control (provided) (Z pg. 40, 41).
Power Switch
Power lamp
Rewind Button
Fast-Forward Button
Play/Pause Button
Stop Button
NOTES:
If Stop mode continues for 5 minutes when power is supplied from a battery, the camcorder shuts off
automatically. To turn on again, set the Power Switch to “OFF”, then to “ ”.
The playback picture can be viewed in the LCD monitor, viewfinder or on a connected TV (
Z
pg. 32, 33).
You can also view the playback picture on the LCD monitor with it flipped over and retracted.
LCD monitor/viewfinder indications:
When power is supplied from a battery: the “ ” battery pack remaining power indicator is displayed.
When power is supplied through the DC cord: “ ” does not appear.
During Stop mode, none of the indications are displayed.
Copyguarded tapes cannot be played back. Only a blue screen is displayed.
1
Load a tape (Z pg. 9).
2
Set the Power Switch to “ ”. To start playback,
press
4
/6.
To stop playback, press 5.
Press
2
to rewind, or
3
to fast-forward the tape
during Stop mode.
To Control The Speaker Volume . . .
.... slide the Power Zoom Lever (VOL.) towards “+” to
turn up the volume, or towards “” to turn down the
volume.
PLAYBACK
Basic Playback
Power Zoom Lever (VOL.)
Speaker

Related product manuals