EN19
RECORDING
BRIGHT
– – – – –
6
– – – – –
Journalistic Shooting
In some situations different angles of shooting may be
required for more dramatic results.
1
OPEN LCD MONITOR
Make sure the LCD monitor is fully open.
2
TILT LCD MONITOR
Tilt the LCD monitor in the most convenient
direction.
•The LCD monitor can rotate almost full circle (270°:
90° downward, 180° upward).
Self-Recording
You can shoot yourself while viewing your own image in
the LCD monitor.
1
TILT LCD MONITOR UPWARD
Open the LCD monitor and tilt it upward to 180
degrees so that it faces forward.
2
START RECORDING
Point the lens toward the subject (yourself when self-
recording) and start recording.
•During Self-Recording, the “Tape Running”
indicator and warning indications (Z pg. 72, 73)
are the only ones that are shown; they appear
reversed in the display as they would when viewing
a mirror, but are not reversed in the recording.
NOTE:
The tape remaining indicator does not appear during Self-
Recording. However, when the remaining time reaches 2
minutes, the indicator appears showing the remaining
time: (blinking) (blinking)
(blinking)
Brightness Control
You can adjust the brightness of the display by rotating
MENU/SET.
1
ADJUST BRIGHTNESS
Rotate MENU/SET until the brightness indicator moves
and the display reaches its appropriate brightness.
•The brightness indication appears on the display.
•If the viewfinder is pulled out, it is also possible to
adjust its brightness.
MENU/SET Dial
Self-Recording
To Next Page
Loading...
Need help?
General
