EN31
RECORDING
MANUAL
PAUSE
W
H
0
FOCUS
EXPOSURE AUTO
OFF
AUTO
AUTO
W. BALANCE
4
FADER
/ WIPE
END
OFF
TO MODE MENU
P. AE
/ EFFECT
4
FADER / WIPE
SEL.
FADER–BLACK
WIPE–SHUTTER
RANDOM
OFF
FADER–WHITE
P
R
?
W
H
B
K
FADER–MOSAIC
B W
FADER–B.W
A M
P
L
A
Y
O
F
F
C
A
M
E
R
A
5
S
Fade/Wipe Effects
IMPORTANT:
If certain modes of Program AE with special effects
(
Z
pg. 34) are activated, some Fade/Wipe Effects cannot
be used. If you select a Fade/Wipe Effect that is unusable
in the current situation, the indication blinks.
These effects let you make pro-style scene transitions. Use
these to spice up the transition from one scene to the next.
You can also vary transitions from scene to scene.
EFFECT SELECTION
1
SELECT OPERATION MODE
Set the Operation Switch to “ ”. Then set the Power
Switch to “ ” while pressing down the Lock
Button. Pull out the viewfinder fully or open the LCD
monitor fully.
2
ACCESS RECORDING MENU
Press MENU/SET. The Recording Menu appears.
3
ACCESS “FADER/WIPE” MENU
Rotate MENU/SET to move the highlight bar to
“FADER/WIPE”, then press it.
4
SELECT EFFECT
Rotate MENU/SET to move the highlight bar to the
desired function, then press it.
•The FADER/WIPE Menu disappears and the effect is
reserved. The indicator representing the selected
effect appears.
Fade-in
START/STOP
Button
Recording Menu
FADER/WIPE Menu
[Ex.:
FADER – WHITE]
MENU/SET Dial
Display
Fade-out
FADE/WIPE SELECTION
( , , , , , , , ,
, and )
A scene gradually appears on a black, white, or black-and-
white screen (Fade-in or Wipe-in); or disappears, leaving a
black, white, or black-and-white screen (Fade-out or
Wipe-out).
Fade or Wipe works when recording is started or when
you stop recording.
Before the following step, perform the above steps 1
through 4.
5
START OR END RECORDING
Press START/STOP to activate Fade-in/out or Wipe-in/
out.
NOTE:
Z
pg. 32.
Lock Button
Power lamp
Power Switch
Operation Switch
To Next Page
Loading...
