JVC GR-DVX70A

20 EN
RECORDING Basic Recording For Video (cont.)
Shooting While Watching The LCD Monitor
Before the following steps, perform step 1 (Z pg. 18).
2
ENTER RECORD–STANDBY MODE
Make sure the viewfinder is pushed back in. Set the
Operation Switch to “ ” or “ ”. Then, set the
Power Switch to “ ” while pressing down the
Lock Button.
Open the LCD monitor fully.
•The lens cover opens, the power lamp lights and the
camcorder enters the Record-Standby mode.
•The scene you are aimed at appears in the LCD
monitor, with the word “PAUSE” superimposed
upon it.
3
START SHOOTING
Tilt the LCD monitor upward/downward for best
viewability (Z pg. 21) and press START/STOP.
•“ ” appears in the LCD monitor while recording
is in progress.
4
STOP RECORDING
Press START/STOP again to stop recording.
•The camcorder re-enters the Record-Standby mode.
NOTES:
● When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, we recommend that you use the viewfinder
( Z pg. 18).
● To turn the tally lamp off during recording, refer to
pgs. 34 – 39.
● For other notes, refer to pg. 19.
P
L
A
Y
/
P
C
O
F
F
C
A
M
E
R
A
5
S
D
S
C
D
S
C
P
L
A
Y
A M
Power Switch
Lock Button
Power lamp
START/STOP Button
Tally lamp
(lights while
recording is
in progress)
Operation Switch