To Record An Image With A Title/Frame . . .
.... refer to “Superimposing A Title/Frame” (Z pg. 69).
To Remove The Shutter Sound . . .
.... when you don’t want to hear the shutter sound, set
BEEP/TALLY to “OFF” in the System Menu
(Z pg. 34 – 39). The sound is no longer hard from the
speaker.
NOTES:
●
Even if “MULTI-4” or “MULTI-9” is engaged, Snapshot
recording will be performed in the FULL mode during
Digital Zoom. However, the flash will not fire.
●
If Snapshot recording is not possible, “PHOTO” blinks
when PHOTO (SNAPSHOT) is pressed.
●
Even if Programme AE with special effects (
Z
pg. 44,
45) is engaged, certain modes of Programme AE with
special effects are disabled during Snapshot recording.
In such a case, the icon blinks.
●
If shooting is not performed for approx. 5 minutes when
the Power Switch is set to “ ” and power is supplied
from the battery pack, the camcorder shuts off automati-
cally to save power. To perform shooting again, close the
LCD monitor and re-open it. When using the viewfinder,
push back it in and pull it out again.
●
Motor Drive Mode (
Z
pg. 30) is disabled when the
Power Switch is set to “ ”.
●
To reduce the Red-Eye effect of the subject’s eyes when
the flash fires,
Z
pg. 32.
●
When a cable or headphone set is connected to the AV
OUT connector, the shutter sound is not heard from the
speaker.
FRAME
Snapshot mode
with frame*
FULL
Snapshot mode
with no frame*
PIN-UP
Pin-Up mode*
MULTI-4
Multi-Analyser 4
MULTI-9
Multi-Analyser 9
*:There is the sound of a shutter closing.
To Next Page
Loading...
Need help?
General
