JVC GY-HM200U - Clip Continuous Rec

Clip Continuous Rec
0
In normal recording, when the recording stops,
the
image, audio, and accompanying data from
the start till the end of the recording are recorded
as one “clip” on the SD card.
0
This mode allows you to consolidate several
rounds of “startstop recording” into one clip.
Example:
In normal recording, three clips are generated as
Recording 1, Recording 2, and Recording 3.
However, recording in this mode generates only
one clip.
.
(Recorded video and audio)
Completed Clip
Recording 3 Recording 2 Recording 1
Recording 3
Recording 2
Recording 1
(Recording stops)
Press and hold [REC]
(Recording pauses)
Press [REC]
(Recording pauses)
Press [REC]
(Recording resumes)
Press [REC]
(Recording resumes)
Press [REC]
(Recording starts)
Press [REC]
1
Set “Rec Mode” to “Clip Continuous”.
(A P
116 [ Rec Mode ] )
0
Set [Main Menu] B [System] B [Record
Set] B [Rec Mode] to “Clip Continuous”.
0
The display changes (
“STBY” B “STBYC”).
2
Start recording. (Recording 1)
0
Press the
[REC] button to start recording in
Clip Continuous mode.
0
The display changes (“STBYC” B
“RRECC”)
and the card slot status indicator
lights up in red.
3
Pause recording.
0
Press the
[REC] button again to pause
recording. The display changes (“RRECC”
B “STBYC” (yellow text)).
0
The
card slot status indicator remains lighted
in red.
Memo :
0
When the [CANCEL/STOP] button is pressed
while
the camera recorder is paused (STBYC),
the display changes (“STBYC” (yellow text) B
“STBYC” (blinking yellow text) B “STBYC”
(white text)), and a “clip” is generated. The card
slot status indicator lights up in green.
4
Resume recording. (Recording 2)
0
Press the
[REC] button again to resume
recording. The display changes (“STBYC”
(yellow text) B “RRECC”).
0
The
card slot status indicator remains lighted
in red.
5
Pause recording.
0
Press the [REC] button again to pause
recording. The display changes (“RRECC”
B “STBYC” (yellow text)).
0
The
card slot status indicator remains lighted
in red.
6
Resume recording. (Recording 3)
0
Press the
[REC] button again to resume
recording. The display changes (“STBYC”
(yellow text) B “RRECC”).
0
The
card slot status indicator remains lighted
in red.
7
Press and hold the [REC] button.
0
Recording stops and the display changes
(“RRECC” B “STBYC”). A “clip” is
generated.
0
The card slot status indicator lights up in
green.
8
Press the [REC] button again.
0
The display changes (“STBYC” B
“RRECC”)
and the card slot status indicator
lights up in red.
0
A new “clip” is generated from here.
Special Recording
79
Shooting