JVC GZ-MG334 - Initial Setup and Settings; Charging the Battery Pack; Date;Time Setting

14
Necessary Settings before Use
Charging the Battery Pack
1
Close the LCD monitor to turn off the
camera.
2
Attach the battery pack.
Slide the battery pack down until it locks
in place.
Bottom of the Camera
BATT.
3
Connect the AC adapter.
•
If the provided AC adapter is AP-V14E,
connect the power cord to the AC adapter,
and plug the power cord into an AC outlet.
•
The charge lamp blinks to indicate charging
has started.
L
To detach the battery pack
Slide and hold BATT. ( step 2), then
remove the battery pack.
L
To check the remaining battery power
See page 15.
NOTES
•
You can also use the camera with just the
AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.
Date/Time Setting
1
Open the LCD monitor to turn on the
camera.
2
When [SET DATE/TIME!] appears,
select [YES] within 10 seconds.
SET DATE/TIME!
YES
NO
If you do not select within 10 seconds, the
screen disappears. In such case, press
and hold the POWER button and turn the
camera on again.
3
Set the date and time.
DATE TIME
31 01 11 07
2007
Repeat this step to input the day, month,
year, hour and minute.
4
Touch the OK button to fi nish.
L
To change the date and time
1) Touch the MENU button.
2) Select [BASIC SETTINGS], and then
[CLOCK ADJUST].
3) Set the date and time.
L
To return to the previous screen
Select
@
.
L
To quit the screen
Touch the MENU button.
DC Jack
AC Adapter
To AC Outlet
(110V to 240V)