121
w
Symptom Action
The date and time are not displayed. ●
The date and time are only displayed on the STATUS 2 and STATUS 3 Screens in
the Camera mode (during shooting). (
A
Page 94)(
A
Page 95)
No output from the [Y/VIDEO], [PB], and
[PR] video signal output terminals.
●
Is [Output Terminal] in the [A/V Out...] menu correctly set? (
A
Page 86)
Incorrect display on the viewfinder. ●
Is the LCD used with [LCD + VF] in the [LCD/VF] menu set to
A
Off
B
?
(
A
Page 82)
IEEE1394 connection between the camera
recorder and the external device cannot
be established (e.g., no image on the
camera recorder and/or external device).
●
Is the operation mode correctly set? (
A
Page 7)
●
Is the [INT/EXT] IEEE1394 interface terminal switch correctly set?
●
Is the [HD/DV] IEEE1394 terminal mode switch correctly set?
●
Check the connection, such as by removing the IEEE1394 cable and inserting it
again, or by reconnecting the power.
To Next Page
Loading...
