Masterpage:Right-NoTitle0
EN 7
Filename [HRS6960E1-EN.fm]
Page 7 April 22, 2003 3:24 pm
ON-SCREEN DISPLAY
When “O.S.D.” is set to “ON” (墌 pg. 48), various operational indicators appear on the TV screen.
A Operation Mode Indicators
B Tape Speed SP/LP/EP
C Tape Direction
D Index MARK Indicator 墌 pg. 23
E Counter Display
F Tape Remaining Time Indicator 墌 pg. 24
G Audio Mode Display 墌 pg. 22
H Tape Position Indicator
The tape position indicator
appears on the TV screen
when you press
3 or
5 from the Stop mode
or perform an Index Search
(
墌 pg. 21). The position of
“
q” in relation to “0”
(beginning) or “+” (end)
shows you where you are
on the tape.
NOTE:
Depending on the type of tape being used, the tape position
indicator may not appear correctly.
I VPS/PDC Indicator 墌 pg. 28, 30
J Type of Broadcast 墌 pg. 25
K Current Day/Month/Year
L Clock Display
M Channel Position Number and Station Name/
Auxiliary Input Indicator (L-1, L-2, F-1, S-1 or
SAT*)
* When “L-2 SELECT” is set to “SAT” (墌 pg. 42), “SAT” appears
instead of “L-2”.
N Timer Warning Display
A warning appears on the TV screen to tell you that the
timer-recording is to start in 5 minutes if you’re not in the
Timer mode at that time. The warning blinks for the entire 5
minutes leading up to the start of timer recording. To clear
the display, press
& on the remote control.
S-VHS ET Indicator
(S-VHS ET : ON/S-VHS ET : OFF) 墌 pg. 25, 50
O “Cassette Loaded” Mark
Beginning End
HRS6960E-EN.book Page 7 Tuesday, April 22, 2003 3:24 PM
To Next Page
Loading...
