30
ENGLISH
Storing your own sound modes
You can adjust the sound modes to your
preference and store your own adjustments in
memory (USER 1, USER 2, and USER 3).
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step
1
again.
1
Press EQ (equalizer).
The last selected sound mode
is called up.
The next-step-operation
buttons start flashing.
2
Select the sound mode you want to
adjust.
3
Enter the sound adjustment mode.
The following sound
mode adjustment
screen appears on the
display.
4
Make adjustments as you like.
1) Press ¢ or 4 to select the
frequency band—60Hz, 150Hz, 400Hz,
1kHz, 2.4kHz, 6kHz, 12kHz.
Ex.: When you select “Country”
2
Press the number button to select
the sound mode you want.
• This unit has two sound mode selection
screens. To move to the other screen,
press 5 (up) or ∞ (down).
To cancel the sound mode, select “FLAT” in
step
2
.
Note:
For details about the preset settings of each sound
mode, see page 56.
To exit from the sound mode selection
screen, press EQ (equalizer) repeatedly or wait
for about 5 seconds.
Press 5 (up) or
∞ (down).
Ex.: When you press number button 1 to
select “Country”
EN28-31_KD-LH3150_3100[J]f.p65 2/21/03, 10:05 AM30
To Next Page
Loading...
Need help?
General
