(No.MA596<Rev.005>)11/28
97 CD_DSP_SW O CD DSP Switch L: Other sources/
H: CD USB SD source
98 DIM_IN I Dimmer Control Input (for JVC Model) L: Dimmer Detect ON/
H: Dimmer Detect OFF
98 NC O No Use (For KWD Model) keep L output setting
99 REG_FLG I Power Detection L: Detect OFF/
H: Detect ON
100 Vss - GND
101 PVcc - Power supply for I/O circuits
102 MLD O Microcontroller Command Load Signal
103 BCLK I Servo DSP Data Bit Clock
104 LRCK I Servo DSP Data Word Clock
105 CD_SRDATA_CD I Servo DSP Data Input
106 CD_SRDATA_SYS O Servo DSP Data Output
107 Vss - GND
108 MCLK O Microcontroller Command Clock Signal
109 Vcc - Power supply
110 MDATA O Microcontroller Command Data Signal
111 TU_RST O HELIO/CAYMAN (HD) Reset L: Reset ON/
H: Reset OFF
111 NC O No Use (For non DAB/HD model)
112 PVcc - Power supply for I/O circuits
113 SXM_PWR O Power Supply for SXM (For SXM model only) L: PWR Off/H: PWR On
113 NC O No Use (for non SXM model)
114 Vss - GND
115 DRV_CNT O Loading Motor Control Output
116 BEEP O Output for Beep Tone Generator H (Pulse): BEEP/L: OFF
117 DRV_Lo/Ej O Loading Motor Control Output
118 PCB_TEST_MODE I PCB Test Mode Switch L: Normal Mode/H: Check
Mode (After Reset soft-
ware need to check the pin
input. If detect high it
should enter Serial Num-
ber mode)
118 WDT O Watch Dog Timer output L: Normal Mode /
H: Reset by WDT
119 SW2 I CD Mecha SW2
119 DEBUG_2B O For Debug
119 Field Test 2 O RDS data log output (standby for field test)
120 BLKCK I Sub-Code Block Clock Signal
120 Field Test 1 O RDS data log output (standby for field test)
Pin No. Pin Name I/O Application
Processing/Operation/
Description
To Next Page
Loading...
