To Next PageTo Next PageHow to fix JVC KD-R496 when sound cannot be heard?
If you cannot hear any sound from your JVC Car Receiver, first, adjust the volume to the optimum level. If the sound is still not audible, check the cords and connections to ensure they are properly connected.
What to do if sound cannot be heard during playback on JVC KD-R496 Car Receiver?
If you're experiencing a lack of sound during playback on your JVC Car Receiver, try the following steps: * Reconnect your Android device. * If in [AUDIO MODE], launch any media player application. * If still no sound in [AUDIO MODE], relaunch the current media player application or try a different one. * Restart your Android device. If the problem persists, it's possible that the connected Android device is unable to route the audio signal to the unit.
Why does my JVC KD-R496 Car Receiver flash “CANNOT PLAY”?
If your JVC Car Receiver displays “CANNOT PLAY” or fails to detect your connected device, verify that the connected device is compatible with the unit and that your files are in a supported format. If compatibility is not an issue, try reattaching the device.
What to do if JVC Car Receiver keeps flashing “NO DEVICE” or “READING”?
If your JVC Car Receiver continuously flashes “NO DEVICE” or “READING,” try these solutions: first, switch off the developer options on your Android device. If that doesn't work, reconnect the Android device. If the issue persists, the connected Android device may not support [AUTO MODE].
Why can't I playback at [AUTO MODE] on JVC KD-R496 Car Receiver?
If you cannot playback in [AUTO MODE] on your JVC Car Receiver, ensure that the JVC MUSIC PLAY APP is installed on your Android device. If it is, try reconnecting the Android device and selecting the appropriate control mode. If the problem continues, your connected Android device may not support [AUTO MODE].
How to stop JVC Car Receiver playback from being intermittent?
If you experience intermittent playback or skipping sounds on your JVC Car Receiver, try turning off the power saving mode on your Android device.
Why are correct characters not displayed on JVC Car Receiver?
If your JVC Car Receiver is not displaying the correct characters, note that the unit can only display uppercase letters, numbers, and a limited number of symbols. Also, depending on the display language selected, some characters may not be displayed correctly.
General| Maximum Output Power | 50W x 4 |
|---|---|
| RMS Power Output | 22W x 4 |
| Pre-Output Level | 2.5V |
| Speaker Impedance | 4-8 ohms |
| Frequency Response | 20Hz - 20kHz |
| Signal to Noise Ratio | 80dB |
| Display Type | LCD |
| Audio Formats | MP3, WMA |
| Tuner Type | AM/FM |
| Bluetooth | Yes |
| USB Port | Yes |
| AUX Input | Yes |
| Remote Control | Yes |
| Channels | 4 |
| Detachable Faceplate | Yes |
| Steering Wheel Control Compatible | Yes |
| Pre-Output Impedance | 10 kOhm |
| Playback Media | CD, USB, AUX |
| Preset Stations | 18 FM / 6 AM |
| Preamp Outputs | 2 |
Identifies the specific models covered by this manual.
Crucial information for safe and proper product use.
Serious safety hazards and precautions to avoid.
Configuration of fundamental system, source, and update settings.
Configuring how audio signals are routed to speakers.
Common issues and their solutions applicable to the entire system.
Solutions for problems related to specific media sources (Radio, CD/USB, Android).
Critical safety precautions during installation and wiring.
Detailed instructions and diagrams for connecting the unit's wiring.
