JVC KD-R618

Maintenance
Howto clean the connectors
Frequent detachment will deteriorate the
connectors.
To minimize this possibility, periodically wipe
the connectors with acotton
swab or cloth
moistened with alcohol, being
careful not to
damage the connectors.
To keep discs clean
Adirty disc may not play
correctly. If a disc does become
dirty,
Wipe it with a soft cloth
in astraight line from center to
edge.
• Do not use any solvents (for example,
conventional record cleaner, spray, thinner,
benzine, etc.) to clean discs.
-
Stick-on label
C-thru Disc
(semitransparent
disc)
•
Single CD-8 cm I
Warped disc
(3-3/16") disc
~I
~ I
Sticker and sticker I
residue I
Unusual shape
--
Transparent or I
semitransparent I
parts on its recording I
!
area I
~I
Do not use the following discs:
To play new discs
New discs may have some
rough spots around the inner
and outer edges. If such a disc
is used, this unit may reject the
disc.
To remove these rough spots, rub the edges
with a pencil or ball-point pen, etc.
Connectors
How to handle discs
When removing a disc
from its case, press down
the center holder
of the case
and lift the disc out, holding
it
by the edges.
• Always hold the disc by the edges. Do not
touch
its recording surface.
When storing a disc in its case, gently insert
the
disc around the center holder (with the
printed
surface facing up).
• Make sure to store discs in cases after use.
Moisture condensation
Moisture may condense on the lens inside the
unit
in the following cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the unit may malfunction.
In this case, eject the disc and leave the unit
turned
on for afew hours until the moisture
has evaporated.
ENGLISH I 35