EasyManua.ls Logo

JVC KS-FX222 - User Manual

JVC KS-FX222
82 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
KS-FX222
KS-F172
GET0111-001B
[E/EX]
INSTRUCTIONS
BEDIENUNGSANLEITUNG
MANUEL D’INSTRUCTIONS
GEBRUIKSAANWIJZING
CASSETTE RECEIVER
CASSETTEN-RECEIVER
RADIOCASSETTE
RADIO/CASSETTESPELER
ENGLISH
DEUTSCH
NEDERLANDS
FRANÇAIS
For installation and connections, refer to the separate manual.
Für den Einbau und die Anschlüsse siehe das eigenständige Handbuch.
Pour l’installation et les raccordements, se référer au manuel séparé.
Bijzonderheden over de installatie en aansluiting van het apparaat vindt u in de desbetreffende
handleiding.
KS-FX222
KS-F172
SEL
S.BASS
DISP
SSM
SCMMO/RND
7 9 10 12118
CD-
CH
AM
FM
KS-FX222
CD CHANGER CONTROL
SEL
S.BASS
DISP
SSM
SCMMO
EX
AM
FM
KS-F172
Cover001BKS-FX222_F172[E]ff.p65 4/10/03, 12:47 PM3

Table of Contents

Other manuals for JVC KS-FX222

Questions and Answers

  • W
    williamcuevasAug 8, 2025
    Why is there no sound from the speakers of my JVC KS-FX222?
    • A
      Alexis Mcclure MDAug 8, 2025
      If you cannot hear any sound from the speakers, there might be a few reasons. First, the connections could be incorrect, so check the cords and connections. Second, the volume level might be set to the minimum; try adjusting it to an optimum level. Finally, the built-in microcomputer may be malfunctioning due to noise. To resolve this, press and hold both the SEL (select) and buttons at the same time for several seconds to reset the unit. Note that this will erase the clock setting and preset stations stored in memory.
  • Y
    yruizAug 12, 2025
    Why does the sound keep cutting out on my JVC KS-FX222?
    • M
      Matthew HarrisAug 12, 2025
      Sound interruptions can occur due to several reasons. Ensure that all connections are correctly and securely connected. Also, check that the volume isn't set too low; adjust it to a more audible level. If the problem persists, the built-in microcomputer may be malfunctioning due to external noise. Try resetting the unit by pressing and holding both the SEL (select) and buttons simultaneously for a few seconds. Keep in mind that this will reset the clock and erase preset stations.
  • M
    Michael MartinezAug 16, 2025
    What to do if the CD changer on my JVC Car Receiver is not working?
    • S
      Sharon GutierrezAug 16, 2025
      If the CD changer isn't working, consider these potential causes: * There might be no CD in the magazine, so insert CDs. * CDs might be inserted incorrectly; ensure they are correctly placed. * The magazine itself might not be loaded; insert the magazine into the CD changer. * The unit might not be correctly connected to the CD changer; ensure proper connection and press the reset button on the CD changer. * The built-in microcomputer may function incorrectly due to noise; try resetting the unit by pressing and holding both the SEL (select) and buttons at the same time for several seconds. Note that the clock setting and preset stations stored in memory will be erased.
  • D
    Danielle JohnsonAug 21, 2025
    How to fix “NO CD” message on my JVC KS-FX222 Car Receiver?
    • K
      Kristen HallAug 21, 2025
      The “NO CD” message indicates that the unit isn't detecting a CD. Here are a few possible reasons and solutions: * No CD might be in the magazine; insert CDs into the magazine. * CDs might be inserted incorrectly; make sure they are inserted correctly. * There might be no magazine loaded in the CD changer; insert the magazine. * The unit might not be correctly connected to a CD changer; ensure it is properly connected and press the reset button on the CD changer. * The built-in microcomputer may be malfunctioning; reset the unit by pressing and holding both the SEL (select) and buttons simultaneously for several seconds. Be aware that this will erase the clock setting and preset stations.
  • B
    Brittany CarlsonAug 26, 2025
    Why is SSM not working on my JVC Car Receiver?
    • A
      Angela RobersonAug 26, 2025
      If the SSM (Strong-station Sequential Memory) automatic preset isn't working, it could be due to weak signals. In this case, store stations manually. Alternatively, the antenna might not be firmly connected; ensure the antenna is securely connected.
  • S
    Steven ChristensenAug 30, 2025
    What to do if the tape sound is very low on my JVC KS-FX222 Car Receiver?
    • A
      Alyssa MontgomeryAug 30, 2025
      If the tape sound is at a very low level and the sound quality is degraded, the tape head may be dirty. Clean it with a head cleaning tape.
  • K
    Kenneth JacksonSep 2, 2025
    Why can't I insert a cassette tape into my JVC Car Receiver?
    • O
      Olivia JonesSep 3, 2025
      If you cannot insert a cassette tape, you may be trying to insert it the wrong way. Insert the cassette with the exposed tape facing right.

JVC KS-FX222 Specifications

General IconGeneral
USB PortNo
BluetoothNo
Display TypeLCD
CD Changer ControlNo
WMA PlaybackNo
AAC PlaybackNo
Detachable FaceYes
Tuner TypeFM/AM
EqualizerYes
DIN Size1 DIN
Tuner BandsAM/FM

Related product manuals