Washer (ø5)
ÂUJŠ« WIKŠ
©µ dD® qOu²«
Lock nut (M5)
® XO³¦²« WuLM5©
Rubber cushion
WOÞUD*« …uA(«
Handles
UU*«
Power cord
WOzUÐdNJ« WUD« pKÝ
Trim plate
WM¹e« WŠu
Sleeve
w«u« qJON«
• When installing the unit without using the sleeve
In a Toyota for example, first remove the car radio and install the unit in its place.
ŽKv ݳOq «*¦U‰¨ w ÝOU—« ½uŸ ðu¹uðU¨ «½eŸ —«œ¹u «OU—… «Ëô ÐFb –p —ÒV «'NU“ w JU½tÆ
•
w«u« qJON« «b²Ý« ÊËbÐ “UN'« Vdð UbMŽw«u« qJON« «b²Ý« ÊËbÐ “UN'« Vdð UbMŽ
w«u« qJON« «b²Ý« ÊËbÐ “UN'« Vdð UbMŽw«u« qJON« «b²Ý« ÊËbÐ “UN'« Vdð UbMŽ
w«u« qJON« «b²Ý« ÊËbÐ “UN'« Vdð UbMŽ
• When using the optional stay
•
XO³¦²K wU{« bM «b²Ý« bMŽXO³¦²K wU{« bM «b²Ý« bMŽ
XO³¦²K wU{« bM «b²Ý« bMŽXO³¦²K wU{« bM «b²Ý« bMŽ
XO³¦²K wU{« bM «b²Ý« bMŽ
Sleeve
Lock nut
XO³¦²« WuL
w«u« qJON«
Note: When installing the unit on the mounting bracket, make sure to use the 6 mm-long screws. If
longer screws are used, they could damage the unit.
∫WEŠö∫WEŠö
∫WEŠö∫WEŠö
∫WEŠöWUŠ w ÆrK ∂ ‰uÞ wž«dÐ Âb²Ý« s bQð ¨XO³¦²« WOH² vKŽ “UN'« VOdð bMŽ
Æ“UN'« —d{ Ë« nKð V³¹ Ê« sJ1 p– ÊU ¨rK ∂ s ‰uÞ« wž«dР«b²Ý«
Bracket*
Mounting bolt
VOd²« —UL
Screw (option)
©wU{«® wždÐ
Stay (option)
XO³¦ð bM
©wU{«®
Dashboard
…—UO« uKÐUð
Fire wall
s W¹UL(« —«bł
o¹d(«
Washer
ŠKIW «ŠJUÂ
«²uOq
* Not included with this unit.
*
Ëe dOžÒÆ“UN'« «c¼ l œ
® …bŽUI« W¹u² wž«dÐM5©rK ∂ ™ *
Flat type screws (M5 x 6 mm)*
XO³¦²« WOH²*
…bŽUI« W¹u² wž«dÐ
®M5©rK ∂ ™ *
Flat type screws (M5 x 6 mm)*
Pocket
VOł
Bracket*
XO³¦²« WOH²*
Removing the unit
• Before removing the unit, release the rear section.
1
Remove the control panel.
2
Remove the trim plate.
3
Insert the 2 handles into the slots, as shown. Then, while gently
pulling the handles away from each other, slide out the unit.
(Be sure to keep the handles after installing it.)
…—UO« uKÐUð s “UN'« Ÿe½…—UO« uKÐUð s “UN'« Ÿe½
…—UO« uKÐUð s “UN'« Ÿe½…—UO« uKÐUð s “UN'« Ÿe½
…—UO« uKÐUð s “UN'« Ÿe½
•ÆwHK)« ¡e'« —dŠ ¨“UN'« Ÿe½ q³
±±
±±
±
ÆrJײ« WŠu Ÿe½«
≤≤
≤≤
≤ÆWM¹e« WŠu Ÿe½«
≥≥
≥≥
≥Æq?J?A?« w? 5?³? u?¼ U?L? ¨‚u?I?A?« q?š«œ 5?²U*« qšœ«
s?Ž …b?Š«u« «bOFÐ WUDKÐ 5²U*« V×Ý ¡UMŁ« ¨p– bFÐ
ÆÃ—U)« v« “UN'« V×Ý« ¨Èdšô«
©“UN'« VOdð bFÐ 5²U*UÐ pþUH²Š« s bQ𮩓UN'« VOdð bFÐ 5²U*UÐ pþUH²Š« s bQð®
©“UN'« VOdð bFÐ 5²U*UÐ pþUH²Š« s bQ𮩓UN'« VOdð bFÐ 5²U*UÐ pþUH²Š« s bQð®
©“UN'« VOdð bFÐ 5²U*UÐ pþUH²Š« s bQð®
31
2
Handle
WU*«
Parts list for installation and connection
The following parts are provided with this unit.
After checking them, please set them correctly.
qOu²«Ë VOd²« ¡«eł« WLzUqOu²«Ë VOd²« ¡«eł« WLzU
qOu²«Ë VOd²« ¡«eł« WLzUqOu²«Ë VOd²« ¡«eł« WLzU
qOu²«Ë VOd²« ¡«eł« WLzU
Æ“UN'« l …œËe WOU²« ¡«ełô«
Æ`O× qJAÐ rN³Odð vłd¹ ¨¡«ełô« Ác¼ h× bFÐ
Hard case
VK ‚ËbM
Mounting bolt (M5 x 20 mm)
® VOd²« —ULM5©rK ≤∞ ™
• !"#
!"
!
!"
!
!
• !"#$%&'($
!"#$%&'()*+,6mm !"#$%&' !"()*+,-#
!TOYOTA !"#$%&'()*+,-.)/012&3456
! (M5 x 6 mm)*
* !"#$
*
*
! (M5 x 6 mm)*
!
• !"#$%&!"'()*+,-.(/012
1
!"#
2
!"#
3
!"#$%&'()*+,-."/01234$5
!"#$%&'() *+
!"#$%&'()*+,-.
!"
!"#$%&'(
!"#$%&'()
!"#$%&'()*
!
!"#$%&
!"
!"
! (M5)
(ø5)
! (M5 x 20 mm)
•
•
•
Install.KS-FX250[U]/f 02/14/2000, 1:55 PM2