JVC KW-R930BTS

ENGLISH
38
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Part list for installation
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2 Connect the wires properly.
See Wiring connection.
( 39)
3 Install the unit to your car.
See Installing the unit (in-dash mounting).
4 Connect the terminal of the car battery.
5 Press to turn on the power.
6 Reset the unit. ( 3)
Use only the specified screws. Using wrong screws might damage
the unit.
INSTALLATION/CONNECTION
Installing the unit (in-dash mounting)
Install onto the car brackets using the supplied screws (B) or (C) . The screw holes differ depending on the model
of the cars.
Do the required wiring. (  39 )
Dashboard of your car
Car bracket
(A) Wiring harness
(B) Flat head screw M5 × 8mm (M5 × 3/8")
(C) Round head screw M5 × 8mm (M5 × 3/8")
JS_JVC_KW_R935BTS_K_EN_7.indd 38JS_JVC_KW_R935BTS_K_EN_7.indd 38 7/4/2017 2:45:59 PM7/4/2017 2:45:59 PM