JVC KW-V215DBT - BLUETOOTH - Call and Audio Settings; Adjusting Call Volume and Switching Modes; Making Calls via Bluetooth

ENGLISH 31
BLUETOOTHBLUETOOTH
R Adjusting the volume of calls/earpiece/
microphone
While talking...
• You can adjust the volume level between –20 to
+8 (initial: 0).
• Use the monitor panel to adjust the call/earpiece
volume. (Page7 )
R Switching between handsfree mode
and phone mode
While talking...
Each time you press the button, the talking method
is switched ( : handsfree mode / : phone
mode).
R Notification when SMS is received
If the mobile phone is compatible with SMS (Short
Message Service), the unit tells you a message has
been received when <SMS Notify> is set to [ON].
(Page35)
• To read a received message, operate the mobile
phone after stopping the car in a safe place.
– You cannot read, edit, or send a message
through the unit.
• For some mobile phones, the notification message
may not be shown even if the SMS function is
supported.
R Reducing noise/adjusting the echo
cancel level
While talking...
Activate the noise reduction/echo cancel function
(1), then adjust the level (2).
• To adjust the echo volume (between 1 to 10,
initial: 4): Adjust <EC LEVEL>.
• To adjust the noise reduction volume (between
−5 to −20, initial: −7) : Adjust <NR LEVEL>.
R Making a call
1 Display the <Hands Free> screen.
On the Home screen:
• You can also display the <Hands Free> screen
by pressing / on the monitor panel.
2 Select a method to make a call.
132 4
1
From the phone book/call lists
2
Direct number entry
3
Voice dialing
4
Preset list
• To preset, see page33.
KW-VEntryE.indb31KW-VEntryE.indb31 2014/09/0911:332014/09/0911:33