JVC KW-V215DBT - BLUETOOTH - Connection Management; Connecting and Deleting Registered Devices; Using the Bluetooth Mobile Phone

30
BLUETOOTHBLUETOOTH
R Connecting a registered Bluetooth
device
1 Display the <Bluetooth Setup> screen.
(Page29)
2
3 Select the device you want to connect
(1), then select what you want to use the
device for (2).
[ TEL (HFP)]: for mobile phone
[Audio (A2DP)]: for Bluetooth audio player
• Selectable items depend on the device you
are operating.
• If you connect a device while another device
is connected, the device previously connected
is disconnected and the connection for the
newly connected device is established.
• When a Bluetooth mobile phone is connected,
the signal strength and battery level are
displayed when the information is acquired
from the device.
To disconnect
Select [TEL (HFP)] or [Audio (A2DP)] to disconnect
the Bluetooth device being used for that function
on the <Paired Device List> screen (see the left
column).
R Deleting a registered Bluetooth device
1 Display the <Bluetooth Setup> screen.
(Page29)
2
3 Select a device to delete (1), then delete
the registration (2).
A confirmation message appears. Press [Yes].
Using the Bluetooth mobile phone
R Receiving a call
When a call comes in...
• Call information is displayed if acquired.
• Phone operation is not available while the
picture from the rear view camera is displayed.
(Page27 )
To reject a call
When <Auto Response> is set to [ON] (Page35)
The unit answers the incoming call automatically.
R Ending a call
While talking...
KW-VEntryE.indb30KW-VEntryE.indb30 2014/09/0911:332014/09/0911:33