JVC KW-X830BT - AUDIO SETTINGS; Sound Effects and Output Settings; Speaker Connection Methods

22
ENGLISH
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
AUDIO SETTINGS
SOUND EFFECT
SPACE ENHANCE
(Not applicable for TUNER source.)
SMALL/MEDIUM/LARGE : Virtually enhances the sound space.;
OFF :Cancels.
SND RESPONSE LEVEL1 / LEVEL2 / LEVEL3 : Virtually makes the sound more realistic.;
OFF :Cancels.
SOUND LIFT LOW / MIDDLE / HIGH : Virtually adjust the sound position heard from
the speakers.;
OFF :Cancels.
VOL LINK EQ ON :Boosts the frequency to reduce the noise heard from outside the
car or running noise of the tyres.;
OFF :Cancels.
K2 TECHNOLOGY (Not applicable for TUNER source and AUX source.)
ON :Improve the sound quality of compressed music.; OFF :Cancels.
Speaker output settings [SPK/PRE OUT]
(Applicable only if [X ‘ OVER TYPE ] is set to [2-WAY]) (
21)
Select the output setting for the speakers [SPK/PRE OUT] , based on the
speaker connection method.
Connection via lineout terminals
For connections through an external amplifier. ( 36)
KW-R930BT
:
Setting on
[SPK/PRE OUT]
Audio signal through lineout terminal
FRONT REAR SW
REAR/REAR (default) Front speakers
output
Rear speakers output Subwoofer output
REAR/SUB.W ( Not available ) ( Not available ) ( Not available )
SUB.W/SUB.W Front speakers
output
L (left): Subwoofer output
R (right): (Mute)
Subwoofer output
KW-X830BT :
Setting on
[SPK/PRE OUT]
Audio signal through lineout terminal
FRONT REAR/SW
REAR/REAR Front speakers output Rear speakers output
REAR/SUB.W (default) Front speakers output Subwoofer output
SUB.W/SUB.W Front speakers output Subwoofer output
Connection via speaker leads
For connections without using an external amplifier. However, with this
settings you can also enjoy the subwoofer output.
( 35)
Setting on
[SPK/PRE OUT]
Audio signal through rear speaker lead
L (left) R (right)
REAR/REAR Rear speakers output Rear speakers output
REAR/SUB.W Rear speakers output Rear speakers output
SUB.W/SUB.W Subwoofer output (Mute)
If [SUB.W/SUB.W] is selected:
–
[120HZ] is selected in [SUBWOOFER LPF] and [THROUGH] is not available.
( 23)
– [POSITION R02] is selected in [FADER] and selectable range is [POSITION
R15]
to [POSITION 00] . ( 21)
JS_JVC_KW_R930BT_M_EN_4.indd 22JS_JVC_KW_R930BT_M_EN_4.indd 22 7/26/2017 3:35:42 PM7/26/2017 3:35:42 PM