JVC KW-XC407

(No.MA235)1-11
3.1.10 Removing the CD mechanism control board
(See Fig.10)
• Remove the front panel assembly, heat sink, rear bracket, bot-
tom chassis assembly and middle chassis assembly.
(1) From the inside of the top chassis assembly, disconnect
the card wire from the connector CN601
on the CD mech-
anism control board.
(2) Remove the five screws N attaching the CD mechanism
control board.
(3) Lift the CD mechanism control board to remove the joint f
and remove the joint g in the direction of the arrow.
Fig.10
3.1.11 Removing the CD mechanism assembly
(See Fig.11)
• Remove the front panel assembly, heat sink, rear bracket, bot-
tom chassis assembly, middle chassis assembly and CD
mechanism control board.
(1) From the inside of the top chassis assembly, remove the
three screws P attaching the CD mechanism assembly.
(2) Take out the CD mechanism assembly from the top chas-
sis.
Reference:
When attaching the CD mechanism assembly, set the projec-
tions h of the top chassis assembly in the holes of the CD
mechanism assembly.
Fig.11
CD mechanism control board
CN601
N
N
N
g
f
Top chassis assembly
CD mechanism assembly
P
P
h h
Top chassis assembly