JVC KW-XC407

(No.MA235)1-9
3.1.5 Removing the cassette mechanism control board
(See Fig.6)
• Remove the front panel assembly, heat sink, rear bracket and
bottom chassis assembly.
(1) From the inside of the bottom chassis assembly, discon-
nect the card wire from the connector CN403
on the cas-
sette mechanism control board.
(2) Disconnect the wire from the connector CN402
on the cas-
sette mechanism control board.
(3) Remove the three screws G attaching the cassette mech-
anism control board.
(4) Take out the cassette mechanism control board from the
bottom chassis assembly.
Reference:
• When attaching the cassette mechanism control board, set
the projections d of the bottom chassis assembly in the
holes of the cassette mechanism control board.
• After attaching the cassette mechanism control board, fix
the wire with the wire clamp as before.
Fig.6
3.1.6 Removing the cassette mechanism assembly
(See Fig.7)
• Remove the front panel assembly, heat sink, rear bracket and
bottom chassis assembly.
(1) From the inside of the bottom chassis assembly, discon-
nect the card wire from the connector CN403
on the cas-
sette mechanism control board.
(2) Disconnect the wire from the connector CN402 on the cas-
sette mechanism control board.
(3) Remove the four screws H attaching the cassette mecha-
nism assembly.
Reference:
After attaching the cassette mechanism control board, fix the
wire with the wire clamp as before.
Fig.7
G
G
d
d
d
CN403CN402
Wire clamp
Cassette mechanism control board
Bottom chassis assembly
CN403
CN402
Wire clamp
Cassette mechanism control board
Bottom chassis assembly
H
H
H
Cassette mechanism assembly