Figures and illustrations in this User
Manual are provided for
reference only and may differ slighty from actual product appearance.
Package contents
2. Insert the batteries supplied into the remote control. Make sure that you insert the
batteries correctly with the polarity as shown inside the battery compartment.
3. Replace the battery compartment cover and push in the opposite direction to the arrow
until it clicks into place.
Getting started
Fitting the stand
Before you can install your TV set, you need to fit the stand. Alternatively, you can mount it
on the wall. A Phillips screwdriver is needed to perform the installation.
Setting up the TV set
Place your TV set on a flat, stable surface (e.g. a table or a specially designed TV stand).
Make sure that all cables are laid simply and safely and do not represent a trip hazard. The
device must be connected to a mains socket using the mains cable. This mains socket must
be easily accessible so that the mains plug can be removed immediately in the event of an
emergency.
Fitting the batteries into the remote control
1. Turn the remote control over with its underside facing upwards, insert a finger into the
recess, and push the battery compartment cover in the direction of the arrow. Remove
the battery compartment cover.
The remote control uses 2 x 'AAA' batteries (included).
1 x 55” 4KKKKKK QLED TV
2 x Base Stands
4 x Screws
1 x Remote Control
2 x AAA Batteries
1 x Instruction Manual
1 x Quick Start Guide
1 x Warranty Card
K
1 x 3.5mm to RCA connector cable
To Next Page
Loading...
Need help?
General
