14
FM Radio Operation
• The search may not stop at a station with a very weak signal.
• If reception is poor, move the unit to a stronger signal location.
Press SOURCE button repeatedly to select the tuner source. The display will show “TUNER”.
Tuning in a Station
Auto Tuning
1. Press and hold
button to start auto tuning. The screen will show AUTO and then start
auto tuning. Press
button again to stop the auto tuning.
2. The searched radio stations will be stored as preset station.
The search may not stop at a station with a very weak signal.
Recalling a preset station
1. Press button and the display will show P-XX (from P-01 to P-30).
2. Press
TUNE– / TUNE+ button to select your desired preset station.
Manual Tuning
Press and hold or button to start the forward or reverse scanning. The display will
show the frequency being searched. Once a station has been found, the scanning will stop
automatically.
With FM radio it may be necessary to ne tune each station by pressing or button repeatedly.
Each press will adjust the frequency by 0.05MHz. If reception is still poor, try moving the unit to another
location.
MX-D719PB_IB_Final190704V2.indd 14 05/07/2019 09:48
To Next Page
Loading...
Need help?
General
