JVC MX-DVB10 - Main Board and Regulator;Transformer Removal; Removing the Main Board

MX-DVB10
1-12
Prior to performing the following procedures, remove
the metal cover, the tuner board, the DVD changer
mechanism assembly, the rear panel, the power
supply board, the amplifier board (1, 2), the main
board, the speaker terminal board and AV output
board.
Disconnect the wire from connector CN204 on the
regulator board.
Remove the two screws marked N attaching the
regulator board.
Remove the four screws marked M attaching the
transformer.
1.
2.
3.
Removing the regulator board / power
transformer assembly
(See Fig.28)
Prior to performing the following procedures, remove
the metal cover, the tuner board, the DVD changer
mechanism assembly, the rear panel, the power
supply board, the amplifier board and AV output
board.
Disconnect the card wires from the connector
CN500, CN505 and CN510 on the main board.
Disconnect the flat wires from the connector CN220
on the transformer board.
Disconnect the connector CN530 and CN531 on the
main board from the regulator board.
Remove the screw marked L attaching the main
board on the right side of the body.
1.
2.
3.
4.
Removing the main board
(See Fig.26, 27)
Fig.26
Fig.27
Fig.28
Power
transformer
assembly
Regulator
board
CN204
Transformer
board
M
M
N
Regulator board
Plastic
holder
Plastic rivet
Main board
Front panel assembly
L
CN531
CN530
Regulator board
Front panel
assembly
Hook
CN500
CN505
CN510
CN220
Main board
Transformer
board