JVC NX-F3

19
Basic operations of disc/file playback
Basic operations of disc/file playback
*
For the number button usage, refer to “Using the
number buttons” on page 12.
■ IMPORTANT
• Slide the remote control mode
selector to [AUDIO].
This part explains how to play back the types of
discs shown above.
1 Press 0 on the remote control or
on the main unit.
• The disc tray ejects.
2 Place a disc on the disc tray.
• To play back an 8-cm disc, place it on the
inner hollow of the disc tray.
3 Press [DVD 3].
• If “DVD” is selected as the source, pressing
3 (playback) can start playback.
NOTE
• Instead of using the remote control in step 3, you
can use the buttons on the main unit. Repeat-
edly pressing [SOURCE] can select “DVD” as
the source, and pressing 3 (playback) starts
playback.
• A menu screen may appear on the TV screen
after DVD playback starts. In such a case, oper-
ate the menu screen, using 5, /, 2, 3 (cur-
sor), the number buttons and [ENTER]. (Refer to
“Selecting a chapter/track from the menu
screen” on page 28.)
Number
buttons
*
Remote control
mode selector
5///2/3
(cursor)/
ENTER
3 (playback)
Playing back a disc
Printed surface
Disc tray
NX-F3_NX-F7[A]EN.book Page 19 Tuesday, April 22, 2008 1:55 PM