JVC NX-F3B

(No.MB662<Rev.003>)1-11
3.1.3 Removing the Front panel (See Fig.7 to 9)
(1) Remove the two screws D attaching the Foot. (See Fig.7)
(2) Remove the three screws E attaching the Front panel. (See
Fig.7)
(3) Remove the three screws F attaching the Front panel. (See
Fig.8)
(4) Disconnect the card wire from Micon board connected to
connector CN561
of the Front board. (See Fig.8)
(5) Disengage one hook c of the bottom side of Front panel
and two hooks d engaged both side of Front panel. (See
Fig.7, 9)
Fig.7
Fig.8
Fig.9
E
D
hook c
D
F
CN561
hook d