JVC NX-F3B

1-24 (No.MB662<Rev.003>)
4.5 SPECIAL MODE
4.5.1 DVD STATUS MODE
It perform the following indication state transition, when receive the [POWER] + [STOP] + [2] at POWER ON status.
Come out by any key.
4.5.2 SYSTEM STATUS MODE
It perform the following indication state transition, when receive the [POWER] + [STOP] + [3] at POWER ON status.
Come out by any key.
4.5.3 SPK OUTPUT MEASURE MODE
It shift to the SPK OUTPUT MEASUREMENT MODE, when receive the [POWER] + [STOP] + [4] at POWER ON status.
Normal indicate "MEASURE" to FL, it cancel VOLUME ATT restrictions processing by the sound level detection.
Come out by input again [POWER] + [STOP] + [4].
4.5.4 VERSION INDICATION
It perform the following indication state transition, when receive the [POWER] + [STOP] + [10] at POWER ON status.
Come out by any key.
POWER ON status
1 DVD temp info indication
2 EDID information indication
Normal indication
POWER ON status
1 Indication of a Shutdown cause
2 Indication of the AD port PWR_THERMO: AMP_THERMO: LVL_DET voltage
3 Indication of VOLUME Gain restrictions value.
Effectiveness Gain restrictions value
Gain restrictions value by the temperature
Gain restrictions value by the sound
Normal indication
<POWER ON STATUS>
Attention in use: Because various SAFETY detection processing starts from POWER ON 2 sec. later, shift to
TEST MODE from POWER ON for less than 2 sec. when it want to let you display a
Shutdown cause.
This power measurement mode is for production line.
POWER ON status
SPK OUTPUT MEASURE MODE
Come out mode
POWER ON status
1 Indication of the syscom ROM ver.
2 Indication of the syscom Model/Destination
3 Indication of the Back end firm ver.
4 Indication of the Back end Destination/Region
NORMAL indication