16
NOTES:
• JVC is not responsible for any loss of or damage to iPod that might result from the use of
this product.
• Do not touch or hit the terminals of the dock and of iPod. It might cause damage to these terminals.
• When you connect iPod to the dock, make sure the terminal on the dock is fully inserted into iPod.
• Always set the volume to the minimum level when connecting or disconnecting iPod.
• Do not carry the unit with iPod connected. You might drop it down or it might cause damage to
the connector part.
• Sound distortion may occur when playing back audio sources with a high recording level. When
distortion occurs, it is recommended to turn off the equalizer of iPod. For information on operating
iPod, see the instruction manual for iPod.
• Turn off the unit when disconnecting iPod.
• Remove iPod from the dock when you do not use it.
• When you cannot operate iPod connected through the unit or using the remote control, operate
iPod itself.
• After connecting iPod, wait until the unit is ready for operation (about 3 seconds).
NX-PN10[J].BOOK Page 16 Thursday, April 9, 2009 8:55 AM
To Next Page
Loading...
Need help?
General
