JVC RX-5042S - Video Component Connections

1-10 (No.MB171)
3.11 Removing the power transformer
(See Fig.12)
• Prior to performing the following procedures, remove the top
cover.
(1) From the top side of the main body, remove the tie bands
fixing the wires.
(2) Remove the solders from the soldered section d on the
power transformer board 1.
(3) Remove the solders from the soldered sections e on the
power transformer board 2.
(4) Disconnect the wire from the connector CN251
on the
power transformer board 1.
(5) Remove the four screws M attaching the power
transformer.
(6) Take out the power transformer from the main body.
3.12 Removing the power/fuse board
(See Fig.12)
• Prior to performing the following procedures, remove the top
cover.
(1) From the back and top sides of the main body, remove the
screw N and screw P attaching the power/fuse board.
(2) Remove the solders from the soldered sections f attaching
the power cord.
(3) From the reverse side of the power/fuse board, remove the
solders from the soldered sections g attaching the wires.
Fig.12
CN251
Soldered section d
Soldered sections e
Soldered sections f
Soldered sections g
Tie band
Power transforme
r
Power
transformer
board 2
Power cord
M
M
P
N
M
M
Power transformer board 1
Power / Fuse board
Soldered sections g