Selecting different sources for picture and sound
You can watch picture fi'om a video component while listening to
sound fi'om another component. Press one of the audio source
selecting buttons (CD, TAPEiCDR, FMiAM), while viewing the
picture fi'om a video component such as the VCR or DVD player,
etc.
On the front panel:
CD TAPE/CDR FM/AM
From the remote control:
On the front panel:
To increase the volume, turn MASTER
VOLUME clockwise.
To decrease the volume, turn it
counterclockwise.
• When you turn MASTER VOLUME rapidly_
the volnme level also changes rapidly.
• When you turn MASTER VOLUME slowly,
the volnme level also changes slowly.
From the remote control:
To increase the volume, press VOLUME +.
To decrease the volume, pressVOLUME .
CAUTION:
Always set the volume to the minimum before starting any source. If
the volume is set at its high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.
Note:
The volume level can be adjusted within the range of"O" (minimum) to
"80" (maximum).
You must turn off speakers when you listen with headphones.
1.
2.
Connect a pair ofhea@hones to the PHONES jack on the fi'ont
panel.
Press SPEAKERS ON/OFF so that the SPK indicator disappears
from the display.
This cancels the DSP mode cnrrently selected, and activates the
HEADPHONE mode (see below).
• "HEADPHONE" appears and H. PHONE indicator lights
np on the display.
HEADPHONE mode:
This mode can reproduce the LFE channel signals, mixing them
with the fi'ont channel signals. So you will not miss the
subwoofer sounds exen if you listen to a source using the
headphones.
Notes:
• While in the HEADPHONE mode, you cannot use any DSP modes
(see page 18.)
• Activating the speaker cancels the HEADPHONE mode and turns
on the DSP mode previously selected.
CAUTION:
Be sure to turn down the volume before connecting or putting on
headphones, as high volume can damage both the headphones and
your hearing.
- o o
From the remote control ONLY'.
Press MUTING to mute the sound
through all speakers and headphones
connected.
"MUTING" appears on the display and the volume
tnrns off(the volume level indicator goes off).
MUTING
%
To restore the sound, press MUTING again so that "OFF" appears
on the display.
• Turning MASTER VOLUME on the front panel or pressing
VOLUME +/ on the remote control also restores the sound.
9
To Next Page
Loading...
Need help?
General
