Operating JVC's Audio/Video Components
You can operate JVC'S audio and video components with this receiver's remote control, since control signals for JVC
components are preset in the remote control.
IMPORTANT:
FM/AM:
To operate JVC's audio components using this remote control: 1 - 10, +10:
• You need to connect JVC audio components through the COMPU
LINK (SYNCHRO)jacks (see page 25) in addition to the
connections using cables with RCA pin plugs (see page 5).
• Aim the remote control directly at the remote sensor on the receiver.
• If you use the buttons on the front panel, the remote control will not
operate that source. To operate a source with the remote control,
the source must be selected using source selecting buttons on the
remote control.
• To operate the cassette deck or CD recorder using the COMPU
LINK remote control system, set the source name correctly. (See
page 11.)
• Refer also to the manuals supplied with your components.
Tuner
After pressing FMiAM, you can pert'orm the following operations:
Alternates between FM and AM.
Selects a preset channel number directly.
For channel number 5, press 5.
For channel number 15, press +10, then 5.
For channel number 20, press +10, then 10.
Sound control section [AmplifierJ
You can always perfbrm the following operations:
SURROUND: Turns on or offthe Surround modes
Dolby Pro Logic, Dolby Digital, and DTS
Digital Sun'ound.
SURROUND MODE: Selects the DSP modes.
After pressing SOUND, you can perform the following operations:
SUBWOOFER + / -: Adjusts the subwoofcr output level.
CENTER + / -: Adjusts the center speaker output leveh
REAR'L + / -: Adjusts the left rear speaker output level.
REAR.R + / -: Adjusts the right rear speaker output level.
EFFECT: Selects the effect level.
TEST: Turns on or off the test tone output.
Note:
After adjusting sounds, press the corresponding source selecting
button or CD-DISC to operate your target source by using the 10
keys; otherwise, the 10 keys cannot be used for operating your target
source.
cD_
After pressing CD, you can per%nn the %llowing operations on the
CD player:
l_: Starts playing.
I.,_: Returns to the beginning of the current
(or previous) track.
I_.t: Skips to the beginning of the next track.
m: Stops playing.
I|: Pauses playing. To release it, press I_.
1 - 10, +10: Selects a track number directly.
For track number 5, press 5.
For track number 15, press +10, then 5.
For track number 20, press +10, then 10.
For track number 30, press +10, +10, then 10.
26
To Next Page
Loading...
Need help?
General
