COMPU LINK Remete Centrel System
The COMPU LINK remote control system allows you to operate JVC audio components through the remote sensor on
d_e receiven
To use this remote control system, you need to connect JVC audio
components through the COMPU LINK (SYNCHRO)j acks (see
below) in addition to the connections using cables with RCA pin
plugs (see page 5).
• Make sure that the AC power cords of these components are
unplugged befbre connection. Plug the AC power cords only after
all connections are complete.
Cassette deck
CD recorder
COMPULINK-4
_CD player
Notes:
• There are four versions of COMPU LINKremote control system.
This receiver is equipped with the fourth version -- COMPU LINK-
4. This version is added systematic operations with the CD recorder
to the previous version -- COMPU LINK-3.
• If your audio component has two COMPU LINK jacks, you can use
either one. If it has only one COMPU LINK jack, connect it so that it
is the last item in the series of components. (For example, the CD
player in the diagram above.)
• To operate the cassette deck or CD recorder using the COMPU
LINK remote control system, set the source name correctljz
(See page 11.)
• Refer also to the manuals supplied with your audio components.
This remote control system allows you to use tbur functions listed
below.
Remote Control through the Remote Sensor on the
Receiver
You can control the connected audio components through the remote
sensor on the receiver using this remote controh Aim the remote
control directly at the remote sensor on the receiver. For details, see
pages 26 and 27.
Automatic Source Selection
When you press the play (_-) button on a connected component or
on its own remote control, the receiver automatically turns on and
changes the source to the component. On the other hand, if you
select a new source on the receiver or on the remote control, the
selected component begins playing immediately.
In both cases, the previously selected source continues playing
without sound for a f_w seconds.
Automatic Power On/Off [StandhyJ: only_possible
with the COMPU LINK-3 and COMPU LINK-4
connection
Both the CD player and cassette deck (or CD recorder) turn on and
off (standby) along with the receiver.
When you turn on the receiver, the CD player or cassette deck (or
CD recorder) will turn on automatically, depending on which
component has been previously selected.
When you turn offthe recei-_r, both the CD player and cassette
deck (or CD recorder) will turn off (standby).
_Synchronized Recordin£z
Synchronized recording means the cassette deck starts recording as
soon as a CD or a record begins playing.
To use synchronized recording, _bllow these steps:
1. Put a tape in the cassette deck and a disc in the
CD player.
2. Press the record (®) button and the pause (|i)
button on the cassette deck at the same time.
This puts the cassette deck into recording pause.
If you do not press the record (e) button and pause (ii) button at
the same time, the synchronized recording feature will not
operate.
3. Press the play (_) button on the CD playel:
The source changes on the receiver, and as soon as play starts,
the cassette deck starts recording. When the play ends, the
cassette deck enters recording pause, and stops about 4 seconds
later.
Notes:
• During synchronized recording, the selected source cannot be
changed.
• Ifthepowerofanycomponentisshutoffduringsynchronized
recording, the COMPU LINK remote control system may not
operate properly In this case, you must start again from the
beginning.
25