23
English
3
Press FM/AM PRESET 5/∞ to select a
channel number while the channel number
position is flashing.
Ex.: When channel number “3” is selected.
4
Press MEMORY again while the selected
channel number is flashing on the display.
The selected channel number stops flashing.
The station is assigned to the selected channel number.
5
Repeat steps
1
to
4
until you store all the
stations you want.
To erase a stored preset station, store a new station on a
used number.
The station previously stored will be erased.
To Tune in to a Preset Station
On the front panel
1
Select the band (FM or AM).
RX-6030VBK/RX-6032VSL
Press FM or AM.
The last received station of the selected band is tuned in.
RX-5030VBK/RX-5032VSL
Press FM/AM.
The last received station of the last selected band is tuned
in.
• Each time you press the button, the band alternates
between FM and AM.
2
Press FM/AM PRESET 5/∞ repeatedly until
you find the channel you want.
From the remote control
1
Press FM/AM to select the band (FM or AM).
The last received station of the last selected band is tuned
in and the 10 keys now work for the tuner operation.
• Each time you press the button, the band alternates
between FM and AM.
2
Press 10 keys (1 – 10, +10) to select a preset
channel number.
• For channel number 5, press 5.
• For channel number 15, press +10 then 5.
• For channel number 20, press +10 then 10.
• For channel number 30, press +10, +10, then 10.
Note:
When you use 10 keys, be sure that they are activated for the tuner,
not for the CD or other functions. (See page 32.)
Selecting the FM Reception Mode
When an FM stereo broadcast is hard to receive or noisy, you
can change the FM reception mode.
• You can store the FM reception mode for each preset
station. (See page 22.)
Press FM MODE while listening to an FM station.
• Each time you press the button, the FM reception mode
alternates between “AUTO” and “MONO.”
AUTO Normally select this (initial setting).
When a program is broadcast in stereo, you will
hear stereo sound; when in monaural, you will
hear monaural sound. This mode is also useful to
suppress static noise between stations. The
AUTO MUTING indicator lights up on the display.
MONO Select this to improve the reception (but stereo
effect will be lost).
In this mode, you will hear noise while tuning in to
the station. The AUTO MUTING indicator goes off
on the display. (The STEREO indicator goes off.)
EN18-23_RX-60_5030[C]f 02.12.24, 18:4123
To Next Page
Loading...
Need help?
General
