To Next PageTo Next PageWhat to do if JVC RX-7040B Receiver shows OVERLOAD?
If your JVC Receiver displays 'OVERLOAD', switch the power off and then on again. To prevent recurrence, reduce the volume level by at least 10 steps. If the volume was previously set between 0 and 9, lower it to 0.
General| Number of Channels | 5.1 |
|---|---|
| Frequency Response | 20Hz to 20kHz |
| Total Harmonic Distortion | 0.08% |
| Input Sensitivity | 2.5mV (MM), 200mV (line) |
| Dimensions | 17.1 x 5.8 x 14.6 inches |
| Weight | 24.2 lbs |
| Power Output | 100 W per channel (8 ohms, 20 Hz - 20 kHz, THD 0.08%) |
| Tuning range | FM: 87.5 - 108 MHz, AM: 530 - 1710 kHz |
| Signal to noise ratio | 75dB (MM), 95dB (line) |
| Speaker load impedance | 8Ω to 16Ω |
| Video Connections | composite |
| Speaker Impedance | 8 ohms |
Covers electrical, fire, and general safety warnings, plus component-specific precautions.
Details RF emission standards and warnings for US and Canadian regulations.
Steps for basic use, choosing inputs, and turning power on/off.
Automates speaker configuration based on room size and speaker placement.
Helps resolve common operational problems with a cause/solution chart.
