To Next PageTo Next PageWhat to do if JVC AV receiver shows OVERLOAD?
If your JVC AV receiver displays 'OVERLOAD', switch the power off and then on again to attempt to cancel the overload status. As a protective measure, the volume level will be lowered by 10 steps. If your previous volume level was between 0 and 9, it will be reset to 0.
Why does my JVC AV receiver immediately go into standby mode?
If your JVC AV receiver immediately enters standby mode when you switch it on, this indicates a supply voltage error detection. The unit is designed to enter standby mode immediately in such cases.
General| Channels | 5.1 |
|---|---|
| Input Sensitivity | 200 mV (line) |
| Type | AV receiver |
| Power Output | 100W per channel |
| Frequency Response | 20Hz - 20kHz |
| Total Harmonic Distortion | 0.08% |
| Tuning range | FM/AM |
| Speaker load impedance | 6 - 16 ohms |
| Digital inputs | 2 Optical, 1 Coaxial |
| Video Connections | Composite |
FCC compliance and safety warnings for US users.
Safety precautions and regulatory compliance for Canada.
General safety advice for operation and installation.
Diagram and list of all remote control buttons and their functions.
Diagram and description of all controls on the receiver's front panel.
Identifies all connection jacks and ports on the rear of the receiver.
Step-by-step guide for everyday use of the receiver.
How to choose between different connected audio/video sources.
How to control the receiver's volume using front panel or remote.
Setting the receiver to accept analog or digital audio signals.
How to manually tune FM and AM radio stations.
Storing and recalling favorite radio stations.
Automated setup for speaker size and distance.
Manual configuration of speaker system.
Step-by-step guide for various receiver settings.
Manual configuration for subwoofer, speaker size, and surround back.
Adjusting speaker distances for precise sound staging.
Configuring subwoofer output and crossover frequencies.
Registering components connected to the coaxial digital input.
Registering components connected to optical digital inputs.
List of all available sound adjustment parameters.
Step-by-step guide for making sound adjustments.
Modifying frequency response using EQ settings.
Fine-tuning the volume level for each individual speaker.
Customizing sound field effects for surround and DSP modes.
Chart showing surround modes for different software types.
Enabling 7.1-channel reproduction for compatible software.
How to manually select desired surround modes.
Steps to enable and use the DVD MULTI playback mode.
Connecting video components for remote control via receiver.
Different video cable types (S-Video, Composite, Component) for connection.
Solutions for common operational problems with the receiver.
Technical details on the receiver's amplification capabilities.
